SOL-1 This is a set of connector ends to be used with the Meyer 3 solenoid wires. I have come up with this in an effort to make the valve connections more secure. Connect the 3 wires as normal and tape them up. Add this plug and it allows for one easy on/off connection. Works well if having to replace the huge connector that fails on the MD II setup. Click image for a larger view.

$20.00 + tax plus shipping           Sent USPS

CON-1 This is a set of replacement ends for the lights and vehicle of the Meyer Night Saber light system. They are substantially better than the rubber replacement connectors that are available. Use these to replace the corroded, broken rubber connectors you may have now. Click the image for a larger view.

$20.00 + tax plus shipping           Sent USPS

SAB-1 This is a set of replacement ends for the lights of the Meyer Night Saber light system. These will allow you to repair existing Night Saber light connector damage or adapt a set of older lights to the Saber system. I have sold quite a few of these to guys who use their older lights as reserve lights in case they damage a Night Saber while out plowing. Click the image for a larger view.

$20.00 + tax plus shipping           Sent USPS

VEH-1 This is a set of vehicle side replacement connectors for the Meyer Night Saber light system. These will allow you to install Night Saber lights on your older light system without need for the whole module kit or need to remove your existing wiring harness. Click the image for a larger view.

$20.00 + tax plus shipping          Sent USPS